Difference between revisions of "Plane Command"

Revision as of 08:08, 28 July 2014

This page is about a feature that is supported only in GeoGebra 5.0.

Plane[ <Polygon> ]: Creates a plane through the polygon.
Plane[ <Conic> ]: Creates a plane through the conic.
Plane[ <Point>, <Plane> ]: Creates a plane through the given point, parallel to the given plane.
Plane[ <Point>, <Line> ]: Creates a plane through the given point and line.
Plane[ <Line> , <Line> ]: Creates the plane through the lines (if in the same plane).
Plane[ <Point>, <Point>, <Point> ]: Creates a plane through three points.

Note: See also

Plane tools.

@@ Line 1: / Line 1: @@
 <noinclude>{{Manual Page|version=5.0}}</noinclude>{{command|3D}}{{betamanual|version=5.0}}
-;Plane[ <Point >, <Point >, <Point> ]
+;Plane[ <Polygon> ]
-:Creates a plane through three points.
+:Creates a plane through the polygon.
-;Plane[ <Point >, <Line> ]
+;Plane[ <Conic> ]
+:Creates a plane through the conic.
+;Plane[ <Point>, <Plane> ]
+:Creates a plane through the given point, parallel to the given plane.
+;Plane[ <Point>, <Line> ]
 :Creates a plane through the given point and line.
 ;Plane[ <Line> , <Line> ]
 :Creates the plane through the lines (if in the same plane).
-;Plane[ <Point >, <Plane> ]
+;Plane[ <Point>, <Point>, <Point> ]
-:Creates a plane through the given point, parallel to the given plane.
+:Creates a plane through three points.
 {{Note| See also [[Image:Mode_planethreepoint_32.gif]] [[Plane through 3 Points Tool|Plane through 3 Points]] and [[Image:Mode_planepointline_32.gif]] [[Plane Tool|Plane]] tools.}}