Difference between revisions of "Plane Command"
From GeoGebra Manual
Line 1: | Line 1: | ||
<noinclude>{{Manual Page|version=5.0}}</noinclude>{{betamanual|version=5.0}} | <noinclude>{{Manual Page|version=5.0}}</noinclude>{{betamanual|version=5.0}} | ||
{{command|3D}} | {{command|3D}} | ||
− | ;Plane[ <Point3D>, <Point3D>, <Point3D> ] | + | ;Plane[ <Point3D >, <Point3D >, <Point3D > ] |
− | : | + | :Creates a plane through three points. |
− | ;Plane[ <Point3D>, <Plane> ] | + | ;Plane[ <Point3D >, <Plane> ] |
− | : | + | :Creates a plane through the given point, parallel to the given plane. |
Revision as of 10:59, 1 August 2012
This page is about a feature that is supported only in GeoGebra 5.0. |
- Plane[ <Point3D >, <Point3D >, <Point3D > ]
- Creates a plane through three points.
- Plane[ <Point3D >, <Plane> ]
- Creates a plane through the given point, parallel to the given plane.