Difference between revisions of "BarChart Command"
From GeoGebra Manual
(move Category command to Template) 
(move Category command to Template) 
(No difference)

Revision as of 12:09, 18 November 2010
 BarChart[Start Value, End Value, List of Heights]
 Creates a bar chart over the given interval where the number of bars is determined by the length of the list whose elements are the heights of the bars.
 Example: BarChart[10, 20, {1,2,3,4,5} ] gives you a bar chart with five bars of specified height in the interval [10, 20].
 BarChart[Start Value a, End Value b, Expression, Variable k, From Number c, To Number d]
 Creates a bar chart over the given interval [a, b], that calculates the bars’ heights using the expression whose variable k runs from number c to number d.
 Example: If p = 0.1, q = 0.9, and n = 10 are numbers, then BarChart[ 0.5, n + 0.5, BinomialCoefficient[n,k]*p^k*q^(nk), k, 0, n ] gives you a bar chart in the interval [0.5, n+0.5]. The heights of the bars depend on the probabilities calculated using the given expression.
 BarChart[Start Value a, End Value b, Expression, Variable k, From Number c, To Number d, Step Width s]
 Creates a bar chart over the given interval [a, b], that calculates the bars’ heights using the expression whose variable k runs from number c to number d using step width s.
 BarChart[List of Raw Data, Width of Bars]
 Creates a bar chart using the given raw data whose bars have the given width.
 Example: BarChart[ {1,1,1,2,2,2,2,2,3,3,3,5,5,5,5}, 1]
 BarChart[List of Data, List of Frequencies]
 Creates a bar chart using the list of data with corresponding frequencies.
 Note: The List of data must be a list where the numbers go up by a constant amount.
 Examples:
 BarChart[{10,11,12,13,14}, {5,8,12,0,1}]
 BarChart[{5, 6, 7, 8, 9}, {1, 0, 12, 43, 3}]
 BarChart[{0.3, 0.4, 0.5, 0.6}, {12, 33, 13, 4}]
 BarChart[List of Data , List of Frequencies, Width of Bars w]
 Creates a bar chart using the list of data and corresponding frequencies whose bars are of width w.
 Note: The List of data must be a list where the numbers go up by a constant amount
 Examples:
 BarChart[{10,11,12,13,14}, {5,8,12,0,1}, 0.5] leaves gaps between bars.
 BarChart[{10,11,12,13,14}, {5,8,12,0,1}, 0] produces a line graph.