Difference between revisions of "ArePerpendicular Command"
From GeoGebra Manual
Line 1: | Line 1: | ||
− | <noinclude>{{Manual Page|version=5.0}}</noinclude>{{betamanual|version=5.0}} | + | <noinclude>{{Manual Page|version=5.0}}</noinclude>{{command|logical}}{{betamanual|version=5.0}} |
− | + | ||
{{warning|This GeoGebra command is heavily under construction. Expect to encounter various problems when trying it out. The syntax or the output of this command may be subject to change.}} | {{warning|This GeoGebra command is heavily under construction. Expect to encounter various problems when trying it out. The syntax or the output of this command may be subject to change.}} | ||
;ArePerpendicular[ <Line>, <Line> ] | ;ArePerpendicular[ <Line>, <Line> ] | ||
:Decides if the lines are perpendicular. | :Decides if the lines are perpendicular. | ||
Normally this command computes the result numerically. This behavior can be changed by using the [[Prove Command|Prove]] command. | Normally this command computes the result numerically. This behavior can be changed by using the [[Prove Command|Prove]] command. | ||
− | {{example| 1=<div><code><nowiki>ArePerpendicular[Line[(-1, 0), (0, -1)], Line[(0, 0),(2,2)]]</nowiki></code> yields ''true'' since the given lines are perpendicular.</div>}} | + | :{{example| 1=<div><code><nowiki>ArePerpendicular[Line[(-1, 0), (0, -1)], Line[(0, 0),(2,2)]]</nowiki></code> yields ''true'' since the given lines are perpendicular.</div>}} |
{{Note| See also [[AreCollinear Command|AreCollinear]], [[AreConcurrent Command|AreConcurrent]], [[AreConcyclic Command|AreConcyclic]], [[AreEqual Command|AreEqual]], [[AreParallel Command|AreParallel]] commands.}} | {{Note| See also [[AreCollinear Command|AreCollinear]], [[AreConcurrent Command|AreConcurrent]], [[AreConcyclic Command|AreConcyclic]], [[AreEqual Command|AreEqual]], [[AreParallel Command|AreParallel]] commands.}} |
Revision as of 12:20, 22 July 2014
This page is about a feature that is supported only in GeoGebra 5.0. |
Warning: | This GeoGebra command is heavily under construction. Expect to encounter various problems when trying it out. The syntax or the output of this command may be subject to change. |
- ArePerpendicular[ <Line>, <Line> ]
- Decides if the lines are perpendicular.
Normally this command computes the result numerically. This behavior can be changed by using the Prove command.
- Example:
ArePerpendicular[Line[(-1, 0), (0, -1)], Line[(0, 0),(2,2)]]
yields true since the given lines are perpendicular.
Note: See also AreCollinear, AreConcurrent, AreConcyclic, AreEqual, AreParallel commands.