Difference between revisions of "AreCollinear Command"

Revision as of 09:51, 11 October 2017

AreCollinear( <Point>, <Point>, <Point> ): Decides if the points are collinear.

Normally this command computes the result numerically. This behavior can be changed by using the Prove command.

Example: AreCollinear((1, 2), (3, 4), (5, 6)) yields true since all the three points lying on the same line.

Note: See also AreConcurrent, AreConcyclic, AreCongruent, AreEqual, ArePerpendicular, AreParallel commands.

@@ Line 3: / Line 3: @@
 :Decides if the points are collinear.
 Normally this command computes the result numerically. This behavior can be changed by using the [[Prove Command|Prove]] command.
-:{{example| 1=<div><code><nowiki>AreCollinear[(1, 2), (3, 4), (5, 6)]</nowiki></code> yields ''true'' since all the three points lying on the same line.</div>}}
+:{{example| 1=<code><nowiki>AreCollinear((1, 2), (3, 4), (5, 6))</nowiki></code> yields ''true'' since all the three points lying on the same line.}}
 {{Note| See also [[AreConcurrent Command|AreConcurrent]], [[AreConcyclic Command|AreConcyclic]], [[AreCongruent Command|AreCongruent]], [[AreEqual Command|AreEqual]], [[ArePerpendicular Command|ArePerpendicular]], [[AreParallel Command|AreParallel]] commands.}}