Difference between revisions of "Cylinder Command"
From GeoGebra Manual
(added link to InfiniteCylinder command) |
|||
Line 6: | Line 6: | ||
:Creates a cylinder with given radius and with given points as the centers of the top and bottom. | :Creates a cylinder with given radius and with given points as the centers of the top and bottom. | ||
− | {{Note| See also [[Image:Mode_cylinder_32.gif ]] [[Cylinder Tool|Cylinder]] and [[Image:Mode_extrusion_32.gif]] [[Extrude to Prism or Cylinder Tool|Extrude to Prism or Cylinder]] tools.}} | + | {{Note| See also the [[InfiniteCylinder Command|InfiniteCylinder]] command and the [[Image:Mode_cylinder_32.gif ]] [[Cylinder Tool|Cylinder]] and [[Image:Mode_extrusion_32.gif]] [[Extrude to Prism or Cylinder Tool|Extrude to Prism or Cylinder]] tools.}} |
Revision as of 11:22, 25 September 2014
This page is about a feature that is supported only in GeoGebra 5.0. |
- Cylinder[ <Circle>, <Height> ]
- Creates a cylinder with given base and given height.
- Cylinder[ <Point>, <Point>, <Radius> ]
- Creates a cylinder with given radius and with given points as the centers of the top and bottom.
Note: See also the InfiniteCylinder command and the Cylinder and Extrude to Prism or Cylinder tools.