Difference between revisions of "PlaneBisector Command"
From GeoGebra Manual
(command syntax: changed [ ] into ( )) |
|||
| (3 intermediate revisions by 3 users not shown) | |||
| Line 1: | Line 1: | ||
| − | <noinclude>{{Manual Page|version=5.0}}</noinclude>{{command|3D}} | + | <noinclude>{{Manual Page|version=5.0}}</noinclude>{{command|3D}} |
| − | + | ;PlaneBisector( <Point> , <Point> ) | |
| − | ;PlaneBisector | + | :Creates the plane orthogonal bisector between the two points. |
| − | : | + | ;PlaneBisector( <Segment> ) |
| − | ;PlaneBisector | + | :Creates the plane orthogonal bisector of the segment. |
| − | : | ||
Latest revision as of 13:01, 30 September 2017
- PlaneBisector( <Point> , <Point> )
- Creates the plane orthogonal bisector between the two points.
- PlaneBisector( <Segment> )
- Creates the plane orthogonal bisector of the segment.
