Difference between revisions of "AreCollinear Command"
From GeoGebra Manual
(remove warning) |
m |
||
Line 4: | Line 4: | ||
:Decides if the points are collinear. | :Decides if the points are collinear. | ||
Normally this command computes the result numerically. This behavior can be changed by using the [[Prove Command|Prove]] command. | Normally this command computes the result numerically. This behavior can be changed by using the [[Prove Command|Prove]] command. | ||
− | :{{example| 1=<div><code><nowiki>AreCollinear[(1, 2), (3, 4), (5, 6) | + | :{{example| 1=<div><code><nowiki>AreCollinear[(1, 2), (3, 4), (5, 6)]</nowiki></code> yields ''true'' since all the three points lying on the same line.</div>}} |
{{Note| See also [[AreConcurrent Command|AreConcurrent]], [[AreConcyclic Command|AreConcyclic]], [[AreEqual Command|AreEqual]], [[ArePerpendicular Command|ArePerpendicular]], [[AreParallel Command|AreParallel]] commands.}} | {{Note| See also [[AreConcurrent Command|AreConcurrent]], [[AreConcyclic Command|AreConcyclic]], [[AreEqual Command|AreEqual]], [[ArePerpendicular Command|ArePerpendicular]], [[AreParallel Command|AreParallel]] commands.}} |
Revision as of 13:20, 20 July 2015
This page is about a feature that is supported only in GeoGebra 5.0. |
- AreCollinear[ <Point>, <Point>, <Point> ]
- Decides if the points are collinear.
Normally this command computes the result numerically. This behavior can be changed by using the Prove command.
- Example:
AreCollinear[(1, 2), (3, 4), (5, 6)]
yields true since all the three points lying on the same line.
Note: See also AreConcurrent, AreConcyclic, AreEqual, ArePerpendicular, AreParallel commands.