Difference between revisions of "SetPerspective Command"
From GeoGebra Manual
(use numbers rather than letters) |
m |
||
Line 36: | Line 36: | ||
|- | |- | ||
|T | |T | ||
− | |Graphics | + | |3D Graphics |
|} | |} | ||
Revision as of 09:01, 2 July 2014
This page is about a feature that is supported only in GeoGebra 5.0. |
- SetPerspective[ <Text> ]
Changes the layout and visibility of Views. The text parameter describes the desired layout. The text should be a valid expression - Views are represented by variables (letters): the horizontal arrangement of Views is represented by the related letters juxtaposition, and their vertical arrangement by a division symbol /
.
Letter | View |
---|---|
A | Algebra |
B | Probability calculator |
C | CAS |
D | Graphics 2 |
G | Graphics |
L | Construction protocol |
P | Properties |
R | Data analysis |
S | Spreadsheet |
T | 3D Graphics |
Example:
SetPerspective["G"]
makes only the Graphics View visibleSetPerspective["AGS"]
makes Algebra, Graphics and Spreadsheet View visible, aligned horizontallySetPerspective["S/G"]
makes Spreadsheet and Graphics View visible with Spreadsheet on top and Graphics View belowSetPerspective["S/(GA)"]
is similar as above, the bottom part of the screen consists of Graphics View on the left and Algebra View on the right
Instead of these expressions you may also use a text containing a single digit to use a predefined perspective:
Text | Perspective |
---|---|
"1" | Algebra And Graphics |
"2" | Basic Geometry |
"3" | Geometry |
"4" | Table and Graphics |
"5" | CAS and Graphics |
These roughly correspond to "AG", "G", "G", "SG" and "CG" respectively, but may also affect the display of Input Bar and content of Toolbar.