Difference between revisions of "Sector Command"
From GeoGebra Manual
(create official page from pdf) |
(create official page from pdf) |
||
Line 1: | Line 1: | ||
<noinclude>{{Manual Page}}[[Category:Manual (official)|{{PAGENAME}}]]</noinclude> | <noinclude>{{Manual Page}}[[Category:Manual (official)|{{PAGENAME}}]]</noinclude> | ||
+ | {{command|geometry}} | ||
; Sector[Conic, Point A, Point B]: Yields a conic section sector between two points ''A'' and ''B'' on the conic section. | ; Sector[Conic, Point A, Point B]: Yields a conic section sector between two points ''A'' and ''B'' on the conic section. | ||
: Note: This works only for a circle or ellipse. | : Note: This works only for a circle or ellipse. |
Revision as of 05:30, 29 October 2010
- Sector[Conic, Point A, Point B]
- Yields a conic section sector between two points A and B on the conic section.
- Note: This works only for a circle or ellipse.
- Sector[Conic, Number t1, Number t2]
- Yields a conic section sector between two parameter values t1 and t2 on the conic section.
- Note: Internally the following parametric forms are used:
- Circle: (r cos(t), r sin(t)) where r is the circle's radius.
- Ellipse: (a cos(t), b sin(t)) where a and b are the lengths of the semimajor and semiminor axes.