Points and Vectors

From GeoGebra Manual
Revision as of 15:52, 18 April 2011 by Zbynek (talk | contribs)
Jump to: navigation, search

Points and vectors may be entered via Input Bar in Cartesian or polar coordinates (see Numbers and Angles). Points can also be created using Point tools, Vector from Point Tool, Vector between Two Points Tool and a variety of commands.

Note: Upper case labels denote points, whereas lower case labels refer to vectors. This convention is not mandatory.
  • To enter a point P or a vector v in Cartesian coordinates you may use P = (1, 0) or v = (0, 5).
  • In order to use polar coordinates type in P = (1; 0°) or v = (5; 90°).
Note: You need to use a semicolon to separate polar coordinates. If you don’t type the degree symbol, GeoGebra will treat the angle as if entered in radians.

In GeoGebra, you can also do calculations with points and vectors.

  • You can create the midpoint M of two points A and B by entering M = (A + B) / 2 into the Input Bar.
  • You may calculate the length of a vector v using length = sqrt(v * v)
© 2021 International GeoGebra Institute