Plane Command
From GeoGebra Manual
This page is about a feature that is supported only in GeoGebra 5.0. |
- Plane[ <Polygon> ]
- Creates a plane through the polygon.
- Plane[ <Conic> ]
- Creates a plane through the conic.
- Plane[ <Point>, <Plane> ]
- Creates a plane through the given point, parallel to the given plane.
- Plane[ <Point>, <Line> ]
- Creates a plane through the given point and line.
- Plane[ <Line> , <Line> ]
- Creates the plane through the lines (if the lines are in the same plane).
- Plane[ <Point>, <Point>, <Point> ]
- Creates a plane through three points.
Note: See also Plane through 3 Points and Plane tools.