Difference between revisions of "Plane Command"
From GeoGebra Manual
| Line 9: | Line 9: | ||
;Plane[ <Point >, <Plane> ] | ;Plane[ <Point >, <Plane> ] | ||
:Creates a plane through the given point, parallel to the given plane. | :Creates a plane through the given point, parallel to the given plane. | ||
| + | |||
| + | {{Note| See also [[Image:Mode_planethreepoint_32.gif]] [[Plane through three points Tool|Plane through three points]] and [[Image:Mode_planepointline_32.gif]] [[Plane Tool|Plane]] tools.}} | ||
Revision as of 13:41, 22 July 2014
 |
This page is about a feature that is supported only in GeoGebra 5.0. |
- Plane[ <Point >, <Point >, <Point> ]
- Creates a plane through three points.
- Plane[ <Point >, <Line> ]
- Creates a plane through the given point and line.
- Plane[ <Line> , <Line> ]
- Creates the plane through the lines (if in the same plane).
- Plane[ <Point >, <Plane> ]
- Creates a plane through the given point, parallel to the given plane.
Note: See also 
Plane through three points and 
Plane tools.
Plane through three points and 
Plane tools.
