Difference between revisions of "CircumcircularSector Command"
From GeoGebra Manual
m (1 revision) |
(added v4) |
||
| Line 1: | Line 1: | ||
| − | <noinclude>{{Manual Page}}</noinclude> | + | <noinclude>{{Manual Page|version=4.0}}</noinclude> |
; CircumcircularSector[Point A, Point B, Point C]: Creates a circular sector whose arc runs through the three points ''A'', ''B'', and ''C''. Point ''A'' is the starting point and point ''C'' is the endpoint of the arc. | ; CircumcircularSector[Point A, Point B, Point C]: Creates a circular sector whose arc runs through the three points ''A'', ''B'', and ''C''. Point ''A'' is the starting point and point ''C'' is the endpoint of the arc. | ||
| − | + | {{Note| See also [[Circumcircular Sector through Three Points Tool|Circumcircular Sector through Three Points]] tool.}} | |
Revision as of 13:57, 13 February 2011
- CircumcircularSector[Point A, Point B, Point C]
- Creates a circular sector whose arc runs through the three points A, B, and C. Point A is the starting point and point C is the endpoint of the arc.
Note: See also Circumcircular Sector through Three Points tool.
