Circular Sector Tool

From GeoGebra Manual
Revision as of 20:41, 16 November 2009 by K Voss (talk | contribs) (correct icon)
Jump to: navigation, search

This article is about a GeoGebra tool. You can find a list of all tools on this page. If you are searching help how to use tools in general you should read the manual page about tools.

First, select the center point M of the circular sector. Then, select the starting point A of the sector’s arc, before you select a point B that specifies the length of the sector’s arc (also see command CircularSector).
Note: While point A always lies on the sector’s arc, point B does not have to lie on it.
© 2024 International GeoGebra Institute