Difference between revisions of "Circular Sector Tool"

From GeoGebra Manual
Jump to: navigation, search
m (note formatting)
(No difference)

Revision as of 18:16, 24 November 2013


First, select the center point M of the circular sector. Then, select the starting point A of the sector’s arc, before you select a point B that specifies the length of the sector’s arc.
Notes:
  • While point A always lies on the sector’s arc, point B does not have to lie on it.
  • See also CircularSector command.
© 2024 International GeoGebra Institute