Difference between revisions of "Circular Arc Tool"
From GeoGebra Manual
m (type added) |
(added v4 - note formatting) |
||
Line 1: | Line 1: | ||
− | <noinclude>{{Manual Page}}[[Category:Manual (official)|{{PAGENAME}}]]</noinclude> | + | <noinclude>{{Manual Page|version=4.0}}[[Category:Manual (official)|{{PAGENAME}}]]</noinclude> |
{{Tool|icon=Tool Circle Arc Center 2Points.gif|name={{PAGENAME}}|US_version=Circular Arc with Center between Two Points|non-US_version=Circular Arc with Centre between Two Points|type=arc}} | {{Tool|icon=Tool Circle Arc Center 2Points.gif|name={{PAGENAME}}|US_version=Circular Arc with Center between Two Points|non-US_version=Circular Arc with Centre between Two Points|type=arc}} | ||
− | : First, select the center point ''M'' of the circular arc. Then, select the starting point ''A'' of the arc, before you select a point ''B'' that specifies the length of the arc (also | + | : First, select the center point ''M'' of the circular arc. Then, select the starting point ''A'' of the arc, before you select a point ''B'' that specifies the length of the arc (see also [[CircularArc Command|Command]] command). |
− | : Note | + | : {{Note| While point ''A'' always lies on the circular arc, point ''B'' does not have to lie on it.}} |
Revision as of 13:37, 13 February 2011
This tool has different names in different variants of English:
|
- First, select the center point M of the circular arc. Then, select the starting point A of the arc, before you select a point B that specifies the length of the arc (see also Command command).
- Note: While point A always lies on the circular arc, point B does not have to lie on it.