Difference between revisions of "Circular Arc Tool"
From GeoGebra Manual
(correct icon) |
m (type added) |
||
Line 1: | Line 1: | ||
<noinclude>{{Manual Page}}[[Category:Manual (official)|{{PAGENAME}}]]</noinclude> | <noinclude>{{Manual Page}}[[Category:Manual (official)|{{PAGENAME}}]]</noinclude> | ||
− | {{ | + | {{Tool|icon=Tool Circle Arc Center 2Points.gif|name={{PAGENAME}}|US_version=Circular Arc with Center between Two Points|non-US_version=Circular Arc with Centre between Two Points|type=arc}} |
− | |||
− | |||
: First, select the center point ''M'' of the circular arc. Then, select the starting point ''A'' of the arc, before you select a point ''B'' that specifies the length of the arc (also see command [[CircularArc Command|Command]]). | : First, select the center point ''M'' of the circular arc. Then, select the starting point ''A'' of the arc, before you select a point ''B'' that specifies the length of the arc (also see command [[CircularArc Command|Command]]). | ||
: Note: While point ''A'' always lies on the circular arc, point ''B'' does not have to lie on it. | : Note: While point ''A'' always lies on the circular arc, point ''B'' does not have to lie on it. |
Revision as of 23:49, 9 June 2010
This tool has different names in different variants of English:
|
- First, select the center point M of the circular arc. Then, select the starting point A of the arc, before you select a point B that specifies the length of the arc (also see command Command).
- Note: While point A always lies on the circular arc, point B does not have to lie on it.