Difference between revisions of "AreConcyclic Command"
From GeoGebra Manual
(Created page with "<noinclude>{{Manual Page|version=5.0}}</noinclude>{{betamanual|version=5.0}} {{command|logical}} {{warning|This GeoGebra command is heavily under construction. Expect to encounte...") |
|||
Line 3: | Line 3: | ||
{{warning|This GeoGebra command is heavily under construction. Expect to encounter various problems when trying it out. The syntax or the output of this command may be subject to change.}} | {{warning|This GeoGebra command is heavily under construction. Expect to encounter various problems when trying it out. The syntax or the output of this command may be subject to change.}} | ||
;AreConcyclic[ <Point>, <Point>, <Point>, <Point> ] | ;AreConcyclic[ <Point>, <Point>, <Point>, <Point> ] | ||
+ | :Decides if the points are concyclic. | ||
+ | Normally this command computes the result numerically. This behavior can be changed by using the [[Prove Command|Prove]] command. | ||
+ | {{example| 1=<div><code><nowiki>AreConcyclic[(1, 2), (3, 4), (1, 4), (3, 2)]</nowiki></code> yields ''true'' since the points are lying on the same circle.</div>}} | ||
+ | {{Note| See also [[AreCollinear Command|AreCollinear]], [[AreConcurrent Command|AreConcurrent]], [[AreEqual Command|AreEqual]], [[ArePerpendicular Command|ArePerpendicular]], [[AreParallel Command|AreParallel]] commands.}} |
Revision as of 17:18, 31 October 2012
This page is about a feature that is supported only in GeoGebra 5.0. |
Warning: | This GeoGebra command is heavily under construction. Expect to encounter various problems when trying it out. The syntax or the output of this command may be subject to change. |
- AreConcyclic[ <Point>, <Point>, <Point>, <Point> ]
- Decides if the points are concyclic.
Normally this command computes the result numerically. This behavior can be changed by using the Prove command.
Example:
AreConcyclic[(1, 2), (3, 4), (1, 4), (3, 2)]
yields true since the points are lying on the same circle. Note: See also AreCollinear, AreConcurrent, AreEqual, ArePerpendicular, AreParallel commands.