Difference between revisions of "IterationList Command"
From GeoGebra Manual
m (1 revision: tt => code) |
|||
(2 intermediate revisions by 2 users not shown) | |||
Line 1: | Line 1: | ||
− | <noinclude>{{Manual Page|version=4. | + | <noinclude>{{Manual Page|version=4.2}}</noinclude> |
{{command|function}} | {{command|function}} | ||
− | ; IterationList[Function, | + | ; IterationList[ <Function>, <Start Value>, <Number of Iterations n> ] |
− | : {{Example| 1=After defining <code>f(x) = x^2</code> the command <code>IterationList[f, 3, 2]</code> gives you the list '' | + | : Gives you a list of length ''n+1'' whose elements are iterations of the function starting with the start value. |
+ | : {{Example| 1=After defining <code>f(x) = x^2</code> the command <code>IterationList[f, 3, 2]</code> gives you the list ''{3, 9, 81}''.}} | ||
+ | {{Note|1=See also [[Iteration_Command]].}} |
Revision as of 09:54, 5 September 2013
- IterationList[ <Function>, <Start Value>, <Number of Iterations n> ]
- Gives you a list of length n+1 whose elements are iterations of the function starting with the start value.
- Example: After defining
f(x) = x^2
the commandIterationList[f, 3, 2]
gives you the list {3, 9, 81}.
Note: See also Iteration_Command.