Difference between revisions of "AreParallel Command"
From GeoGebra Manual
(remove warning) |
|||
Line 1: | Line 1: | ||
<noinclude>{{Manual Page|version=5.0}}</noinclude>{{command|logical}}{{betamanual|version=5.0}} | <noinclude>{{Manual Page|version=5.0}}</noinclude>{{command|logical}}{{betamanual|version=5.0}} | ||
− | |||
;AreParallel[ <Line>, <Line> ] | ;AreParallel[ <Line>, <Line> ] | ||
:Decides if the lines are parallel. | :Decides if the lines are parallel. |
Revision as of 08:48, 13 September 2014
This page is about a feature that is supported only in GeoGebra 5.0. |
- AreParallel[ <Line>, <Line> ]
- Decides if the lines are parallel.
Normally this command computes the result numerically. This behavior can be changed by using the Prove command.
- Example:
AreParallel[Line[(1, 2), (3, 4)], Line[(5, 6),(7,8)]]
yields true since the given lines are parallel.
Note: See also AreCollinear, AreConcurrent, AreConcyclic, AreEqual, ArePerpendicular commands.