AreCollinear Command
From GeoGebra Manual
This page is about a feature that is supported only in GeoGebra 5.0. |
- AreCollinear[ <Point>, <Point>, <Point> ]
- Decides if the points are collinear.
Normally this command computes the result numerically. This behavior can be changed by using the Prove command.
- Example:
AreCollinear[(1, 2), (3, 4), (5, 6)]]
yields true since all the three points lying on the same line.
Note: See also AreConcurrent, AreConcyclic, AreEqual, ArePerpendicular, AreParallel commands.