## Manual:BoxPlot Command

This page is part of the official manual for print and pdf. For structural reasons normal users can't edit this page. If you found any errors on this page please contact us. Go to the version which can be edited by users.

##### BoxPlot

This article is about GeoGebra command.

##### Command Categories (All commands)

- Algebra Commands
- Chart Commands
- Conic Commands
- Discrete Math Commands
- Function Commands
- Geometry Commands
- GeoGebra Commands
- List Commands
- Logical Commands
- Optimization Commands
- Probability Commands
- Scripting Commands
- Spreadsheet Commands
- Statistics Commands
- Text Commands
- Transformation Commands
- Vector and Matrix Commands
- CAS Specific Commands

- BoxPlot[yOffset, yScale, List of Raw Data]
- Creates a box plot using the given raw data and whose vertical position in the coordinate system is controlled by variable
*yOffset*and whose height is influenced by factor*yScale*. -
**Example:**`BoxPlot[0, 1, {2, 2, 3, 4, 5, 5, 6, 7, 7, 8, 8, 8, 9}]`

- BoxPlot[yOffset, yScale, Start Value, Q1, Median, Q3, End Value]
- Creates a box plot for the given statistical data in interval [
*Start Value, End Value*]. - BoxPlot[ <yOffset>, <yScale>, <List of Raw Data>, <Boolean Outliers> ]
- This allows outliers to be plotted as "X"s rather than included in the boxplot. For this command, outliers are data lying below Q1 - 1.5 * IQR or above Q3 + 1.5 * IQR.
- BoxPlot[ <yOffset>, <yScale>, <List of Data>, <List of Frequencies>, <Boolean Outliers> ]
- This allows data from a frequency table to be easily plotted as a boxplot.